Track joint for secure attachment and proper alignment of track sections.

Designed to be mounted on angle iron bracket. 5' spacing. Typical, 2.5' spacing in storage area.
NOTE: Use Drill Fixture for Drilling Holes. Part No. 25726

Designed to be located between end clamp and intermediate trolley.

Load rating 45 lbs. max. One required per system. 4" long body with cut out for Tow Bar.

Trolley load rating 45 lbs. max. 4" long body with 2.75" dia. aluminum saddle.

One required per system at storage end of track.

Used for drilling holes at proper locations for attachment of hangers, end clamps and end stops.

Push Button Pendants are used in conjunction with hard-wired control festoon systems. Conductix offers a complete line of Push Button Pendants and Radio Controls.

Ask for Pendant & Radio Catalog to get all the details.

In most industrial environments, Push Button Pendants take a lot of abuse. Eventually, they will need to be replaced. When a pendant station has to be replaced, the biggest concerns are always:

• Equipment downtime
• Expense
• Risk of injury to maintenance personnel

CONDUCTIX has the solution to reduce all three of these concerns - the "Quick Disconnect" Pin Connector.

Pendants wired with "Quick Disconnect" Pin Connectors can be replaced in as little as 5 to 10 minutes, versus two hours with a hard-wired pendant. A positive latch mechanism keeps the connector plugged in until you're ready to disconnect the pendant.

The quick-disconnect connectors are available in 16 and 24 pin versions.

You can use Quick Disconnects with radio controls as well. Then you can switch from radio control to a standard pendant quickly and easily.

Contact CONDUCTIX for more information and a quotation on the Quick Disconnect